Paint bucket mould

Paint bucket mould

Description

The key to technology is to come up with the problem. Because the paint bucket is different from other types of buckets, there is a barb on the margin of the mouth of the bucket. This barb (rib) needs to be demolded before it falls. If there are other ribs on the margin of the bucket, we need to use the inclined top

  • Product details page 1

  • Product details page 2

  • Additional Product Information

  • product manual

The key to the paint bucket mold technology is to eject the problem. Because the paint bucket is different from other types of buckets, there is a barb on the margin of the mouth of the bucket. This barb (rib) needs to be demolded before it falls. If there are other ribs on the edge of the bucket, we need to eject the paint bucket with an inclined top.

A good injection mold is a talent that requires maintenance and protection. Increase the life of the mold to make better products. Special daily products such as large molds. We also spray anti-rust agent inside the mold every time after use to prevent the mold surface. Rust, if it is not necessary for a long time, the moving parts such as the ejector pin and the push plate are suggested to be oiled, and the mold waterway should be fully dried, otherwise the waterway will rust, and the appearance can be painted with paint to prevent rust.

Protection in the production process: Do not fill the parameters such as injection pressure and speed. If the load is used at full load, the life will be much shorter. If there is a flashing edge, it may be difficult to solve the problem in a timely manner. This will prevent the problem from expanding. .




Related News

Product Recommended

  • Thin wall products
  • Electrical mould
  • Cup mould
  • Custom Turnover Box M...
  • Paint bucket mould
  • Pallet mould